Heating a stream
Heat a feed to a set outlet temperature and find the duty it takes. Introduces the heater, energy streams and specifying an outlet condition.
About 8 minutes. Skills: heater, energy stream, duty. In the app: Start page › Exercises › Heating a stream.
1. Start a new case and set up the fluid
Tap New case, add Methane, Ethane, Propane and n-Butane, keep Peng-Robinson, and tap Simulation.
2. Add the feed stream
Place a Material Stream and enter 60 °F, 600 psia, 100 lbmole/hr and mole fractions Methane 0.85, Ethane 0.08, Propane 0.05, n-Butane 0.02.
3. Add a heater
Place a Heater. Connect the feed as its inlet and create a new outlet stream. An energy stream (Q-100) is created with the heater.
4. Set the outlet temperature
Open the heater's Worksheet tab (or its outlet stream) and enter an outlet temperature of 150 °F. Leave Delta P at zero on the Parameters page.
Outlet conditions go on the outlet stream; the heater then works out the duty. You could instead give the duty and let Zalosim calculate the outlet temperature.
5. Read the duty
Question: open the heater's Performance tab. What duty does it need?
Duty is the heat added per unit time. It is also shown on the energy stream. The exercise accepts answers within 1 % of your case's value.
Try next
- Swap the heater for a Cooler and cool the gas to 0 °F instead. Note the sign convention: a cooler's duty is the heat removed.
- Move on to the oil and gas cases, starting with the Three-phase separator.