Docs › Tutorials

Three-phase separator

Split a wellstream into gas, oil and produced water in one vessel. Teaches the liquid-liquid split and the 3-Phase Separator.

About 20 minutes. Skills: wellstream, liquid-liquid split, 3-Phase Separator. In the app: Start page › Oil & gas exercises › Three-phase separator. The finished case is under Oil & gas starter cases.

The finished three-phase separator case: Wellstream into V-100 with Gas, Oil and Water outlets

1. Start a new case

On the Start page, tap New case.

2. Set up the fluid

  1. Add the 15 components in the table below. Type part of a name in the search box (for example dec for n-Decane, C16 for n-C16) and tap +.
  2. Under Fluid Packages keep Peng-Robinson.
  3. On the package's StabTest tab, tick Liquid-liquid split (full VLLE), so the feed itself flashes to gas, oil and water.
  4. Tap Simulation.
ComponentMole fractionComponentMole fraction
Nitrogen0.005n-Pentane0.015
CO20.015n-Hexane0.03
Methane0.35n-Heptane0.05
Ethane0.07n-Octane0.05
Propane0.05n-Decane0.06
i-Butane0.015n-C16 (n-hexadecane)0.04
n-Butane0.025H2O0.213
i-Pentane0.012

3. Add the wellstream

Place a Material Stream, rename it Wellstream (tap its name on the Conditions page) and enter:

  • Temperature 150 °F
  • Pressure 300 psia
  • Molar Flow 2000 lbmole/hr
  • The mole fractions in the table above (Composition › Edit…). They must add up to 1.

4. Add a 3-phase separator

Place a 3-Phase Separator. Connect Wellstream as its inlet and create new streams Gas (Vapour), Oil (Liquid, the light liquid) and Water (Water, the heavy liquid). Use << Type a name >> in each picker to name them as you create them.

The vessel needs no specification: it flashes the feed at its own temperature and pressure.

5. Questions

  1. Gas rate. Open the gas outlet. What is its molar flow?
  2. Produced water. Open the water outlet. What is its molar flow? Compare it with the water in the wellstream (0.213 × 2000 lbmole/hr). Almost all the water leaves here; a little stays dissolved in the gas and oil.

Expected results

What Zalosim gives with the inputs above (Peng-Robinson, Field units):

StreamValueResult
WellstreamVapour fraction0.4726
GasMolar flow945.3 lbmole/hr
GasMass flow22546 lb/hr
OilMolar flow641.5 lbmole/hr
OilMass flow69483 lb/hr
WaterMolar flow413.1 lbmole/hr
GasTemperature150.0 °F
GasH2O mole fraction0.01212
OilH2O mole fraction0.002192

Try next

  • Untick Liquid-liquid split on the StabTest tab and read the separator's warning.
  • Continue with Stage separation, which uses the same wellstream.