Docs › Tutorials

Flashing a cold feed

Cool gas until liquid forms, then split the vapour from the liquid in a separator. Introduces two-phase streams and the vapour fraction.

About 12 minutes. Skills: feed stream, two phases, separator, vapour fraction. In the app: Start page › Exercises › Flashing a cold feed.

1. Start a new case

On the Start page, tap New case.

2. Set up the fluid

Add Methane, Ethane, Propane and n-Butane, keep Peng-Robinson, and tap Simulation.

3. Add a cold feed

Place a Material Stream and enter:

FieldValue
Temperature-40 °F
Pressure600 psia
Molar Flow100 lbmole/hr
Mole fractionsMethane 0.85, Ethane 0.08, Propane 0.05, n-Butane 0.02

The keypad's ± key enters negative numbers: type 40, then ±.

4. Add a separator

Place a Separator. Connect the feed as its inlet and create new streams for the Vapour and Liquid outlets. The separator needs nothing else: it flashes the feed at its own temperature and pressure.

5. Questions

  1. How much is vapour? Open the feed stream's Conditions page. What is its vapour fraction? (1 is all gas, 0 is all liquid.)
  2. Liquid product. Open the separator's liquid outlet. What is its molar flow?

The exercise checks the vapour fraction to within 0.005 and the flow to within 1 % of your case's values.

Try next

  • Warm the feed to 0 °F, then 40 °F. Watch the liquid flow fall and the vapour fraction rise.
  • Open the feed's Attachments › Analysis and create an Envelope to see where -40 °F and 600 psia sit relative to the dew point curve.
  • Continue with Heating a stream.